If you have been reading my blog series on how to design inductive sensing with the LDC1000 inductance-to-digital converter since we released it , you know how excited I am about the many uses and design opportunities. But it until now, design could have been a bit complicated when your system required multiple inductive sensors. That’s why I’m now excited to share that TI has expanded our inductive sensing portfolio to include four new 3.3V I2C multichannel devices: the LDC1312, LDC1314, LDC1612 and LDC1614 (see Figure 1).
Figure 1: TI’s new inductive sensing solutions
The LDC1312 and LDC1314 are 12-bit inductance-to-digital converters (LDCs), which can be used for applications such as rotational knobs, keypads or flow meters. The LDC1612 and LDC1614 are 28-bit LDCs, which can be used in high-precision applications such as linear encoders or strain gauges.
Here are some reasons to consider a new LDC device for your next design.
Multichannel operation
With the dual-channel LDC1312 and LDC1612 devices and the quad-channel LDC1314 and LDC1614 devices, system design can become much simpler while also improving cost effectiveness. The inherent channel matching from using a multichannel LDC improves system performance in high-precision designs that either employ differential measurements, or use one coil as a reference to reduce the effect of temperature, mechanical tolerances or other system variables.
Sensitivity
The maximum sensing distance changes with coil diameter. As with the LDC1000, the LDC1312 and LDC1314 operate best if the maximum target distance is kept within 50% of the coil diameter. However, the high-resolution of the LDC1612 and LDC1614 can effectively sense targets as far as two coil diameters away from the sensor.
Power consumption
We significantly improved power consumption of the new LDC family to benefit battery-operated applications. Lowering the supply voltage from 5.0V to 3.3V allowed us to drop power consumption in active mode by 20%, from 8.5 mW to 6.6 mW. Standby-mode power consumption dropped by 91%, from 1.25 mW to 0.11 mW. Additionally, the new LDC family features a pin for shutdown mode, during which the device consumes only 0.2 µA.
In low-sample-rate battery-operated applications, the sleep mode and shutdown mode functions can be used to cycle the LDC. The LDC turns on to perform the conversion and then retunrs to one of the low-power modes. The Inductive Sensing Design Calculator Tool contains a power-consumption estimator for this purpose.
Start designing
Each of the four multichannel devices has a new evaluation module (EVM) (Figure 2), which is available now. Together with our new multichannel EVM software, you can get started with the new features of our inductance-to-digital converters within minutes. You can also check out the EVM and GUI quick-start videos.
In upcoming posts, I will explain how to configure a multichannel system and explore the possibilities that the increased sensing range of the LDC1612 and LDC1614 offer.
Additional resources:
- Learn more about inductive sensing.
- Get started with the LDC1614EVM and software
- Check out a TI Design reference design for a touch-on-metal button design using the LDC1614.
- Check out WEBENCH® Inductive Sensing Designer.
- Read more blogs on inductive sensing design, including Should I measure L, RP or both?